Securus S4 is a 358 rigid mesh security fencing system made up of 2 cassettes, each with 2 panels of 358 mesh. It has a D10 (SR4) rating certified by the Loss Prevention Certification Board and provides a minimum of 10 minutes delay against attack using tools such as bolt cutters, hacksaws, jigsaws, drills, and sledgehammers.

Securus S4 is assembled off-site meaning only a minimal amount of assembly is required on-site for faster installation times and lower risk of downtimes due to lost components.

CLD's Securus range allows complete flexibility – panels can be swapped out to change the security rating as the needs of the site change.

Key Features

  • Double cassette (front & rear)

  • Faster installation and less downtime

  • Tested and certified to LPS 1175 D10 (SR4) / E3 / G1

  • Withstands attack for 10 minutes minimum

  • Baseplate & ground bury options

  • Channel and clamps buried 100mm on non-baseplated options

  • Allows excellent visibility across the site

  • Matching access control options available giving a seamless perimeter

  • Small apertures means that most people cannot get their fingers through

  • Full range of RAL colours available.

Dimensions

Panel width
2518mm

Wire Diameter
4mm

Mesh Size
76.2 x 12.5 mm

Available Heights
2880mm to 5000mm

Nominal Height
2.8m to 5m

Post Dimensions
120mm x 120mm

Post Centres
2530mm +/- 9mm

Finish

Options:

  • Polyester powder-coated to 60-80 microns

  • 160-200 microns with marine grade and metallics

  • Any RAL colour available

Technical Specifications

  • Panel Type: Double layered mesh cassette system. Mesh and wire. Double layered mesh cassette system. Galvanised and powder coated to minimum 80 microns dft

  • Panel Installation: Bottom of panel minimum 100mm below ground or option for maximum 50mm above ground. Base plated and no ground bury options also available.

  • Security topping options: Barbed and razor wire, cranked and straight

  • Posts: SHS, galvanised after manufacture and polyester powder-coated to match fencing

  • Fixings: 120mm x 5mm full length clamp bar. M8 case hardened self-tapping screws and M8 stainless steel cup square bolt (min 160mm) Washers and nyloc nuts

  • Foundations: Set posts in holes minimum 450mm square x 950mm deep. Note: Contractor/ client is responsible for the foundation size suitable for the ground conditions and fence height

  • Warranty: Minimum of 15 years against manufacturing defects