Modsec Dulok S1 is a security fencing solution that pairs Dulok S1 rigid mesh fencing with the Modsec base.

Dulok S1, with its twin 8mm horizontal wires either side of the 6mm vertical wire, is tested and certified to LPS 1175 A1 (SR1) Issue 8, guaranteeing a minimum delay against attack of 60 seconds.

Installed at ground level or as a trench system, it has an in-built channel for wires or services that enable easy installation of CCTV, PIDS and other electronic devices.

Key Features

  • High security anti-cut double wire fence panels

  • Secured by Design accredited

  • For use on flat ground or gradients

  • In-built channel for wires or services that enable installation of electronic devices like CCTV, PIDS

Dimensions

Panel Width
2508mm

Wire Diameter
6mm verticals, twin 8mm horizontals

Mesh Size
200 x 50mm

Heights
1830mm up to 5070mm (Select as appropriate)

Nominal Height
1.8m to 5m

Post
Minimum 60mm x 40mm depending on height of panel

Maximum Post
2520mm

Finish

  • Polyester powder-coated to 60-80 microns

  • 160-200 microns with marine grade and metallics

  • Any RAL colour available

Technical Specification

  • Panel Type: Mesh and wire. Single vertical and double horizontal wires. Installed using ModSec concrete base (see separate ModSec Base Q40) 

  • Top edge projection: 30mm

  • Panel installation: Bottom of panel maximum 50mm above block

  • Security topping options: options available on request

  • Posts: RHS, galvanised after manufacture and polyester powder-coated to match fencing

  • Fixings: 40mm x 5mm full length clamp bar. M8 x 40mm stainless steel pin hex dome-head security screws. Sheardrive™ if required instead of pin hex