ModSec is an innovative installation system for temporary fencing, which can be installed either on ground or in ground as a trench system. It features an in-built channel for wires or services, enabling easy installation of CCTV, PIDS or other electronic devices.

ModSec S3 incorporates CLD’s Securus S3 fence panels.

Tested by the Loss Prevention Certification Board (LPCB), Securus S3 offers a minimum delay against attack of 5 minutes.

The ModSec system is available to hire or purchase.

Key features

  • Can easily be used on flat ground or gradients

  • Built in channel for wires and services

  • Easy to update fencing when threat level changes

  • Security toppings available

  • Hire or purchase

  • Suitable for flat ground or gradients

Dimensions

Panel Width
2520mm

Wire Diameter
4mm

Mesh Size
76.2 x 12.5mm

Available Heights
2440mm to 5000mm

Nominal Heights
2.4m to 5.0m

Post Dimensions
100mm x 100mm

Finish

Options:

  • Polyester powder-coated to 60-80 microns

  • 160-200 microns with marine grade and metallics

  • Any RAL colour available

Technical Specifications

  • Panel Type: Mesh and wire. Double layered mesh cassette system. High aluminium content. (Note: Fence Cassettes are supplied assembled for ease of install, mechanical lifting required – can be supplied unassembled)

  • Panel Installation: Bottom of panel maximum 50mm above block

  • Security Topping Options: Barbed and razor wire, cranked and straight

  • Posts: SHS, galvanised after manufacture and polyester powder-coated to match fencing

  • Maximum Post Centres: 2530mm +/- 9mm

  • Posts: SHS, galvanised after manufacture and polyester powder-coated to match fencing

  • Fixings: 100mm x 5mm full length clamp bar. M8 Stainless Steel cup square bolt (min 100mm) and SafeTFix ™ nut

  • Foundations: Install Modsec foundation on suitable flat ground making sure blocks interlock and posts are installed in every fourth block. Set post into block with suitable compound depending on permanent or temporary installation

  • Warranty: Minimum of 15 years against manufacturing defects