ModSec Securus S1 is a modular temporary security fencing system that uses CLD’s Securus S1 fence panels. It has an in-built channel for wires or services, enabling easy installation of CCTV, PIDS, or other electronic devices.

Tested and certified to LPS 1175 A1 (SR1) Issue 8 ModSec Securus S1 guarantees a minimum delay against attack of 60 seconds.

ModSec Securus S1 can be installed at ground level or as a trench system.

This system is available to hire or purchase.

Key Features

  • Suitable for flat ground or gradients

  • Built-in services channel

  • Easily updated as threat level changes

  • Hire or purchase

  • LPS 1175 Issue 8 A1 security rating

  • Guaranteed minimum 60 second delay against attack

Dimensions

Panel Width
2520mm

Wire Diameter
4mm

Mesh Size
76.2 x 12.5mm

Available Heights
1830mm to 5000mm

Nominal Heights
1.8m to 5m

Post Dimensions
80mm x 60mm
Corner posts: 80mm x 80mm

Finish

Options:

  • Polyester powder-coated to 60-80 microns

  • 160-200 microns with marine grade and metallics

  • Any RAL colour available

Technical Specification

  • Panel Type: Mesh and wire panel installed using ModSec concrete base (see separate ModSec Base Q40)

  • Panel installation: Bottom of panel maximum 50mm above block 

  • Security Topping Options: Barbed and razor wire, cranked and straight

  • Posts - Special flanged post, galvanised after manufacture and polyester powder-coated to match fencing 

  • Maximum post Centres: 2520mm +/- 9mm

  • Fixings: 120mm x 6mm full length clamp bar. M8 Stainless Steel cup square bolt (min 30mm)

  • Foundations: Install using ModSec foundation system. Must be installed on suitable flat ground, ensuringblocks interlock and posts are installed in every fourth block. Set post into block with suitable compound depending on permanent or temporary installation

  • Warranty: Minimum of 15 years against manufacturing defects