Perimeter Drainage Channel can be bedded into a preformed channel at the floor / wall angle and collects water. Holes in the channel walls allow water to ingress to drain away to a sump.

Jetting eyes are available to allow maintenance and inspection.

Features, benefits and applications

  • It can be supplied with or without a 20mm upstand

  • Drainage Conduit for collection of water at floor/wall construction

  • Channel with upstand keeps the channel stable when abutting the Delta membrane on a perimeter wall

  • Channel without upstand is used where cross channels sit over construction joints in the middle of the floor, when Delta Channel is to be offset from the wall or to join two perimeter channels together across a floor

  • Drainage Channel is used to relieve hydrostatic water pressure and is installed below flooring membranes at the floor/wall junction

  • Jetting eyes are available to allow maintenance and inspection

  • Holes in the channel walls allow water to ingress to drain away to a sump

  • Easily linked using Delta connector pieces: Corner Pieces, T pieces, End Caps and 110mm Drainage Outlet

  • Yellow to highlight any build up when inspecting system

Product details

  • Product Code: DMS 207 (With Upstand), DMS 208 (Without Upstand)

  • Width: 80 mm (With Upstand), 80 mm (Without Upstand)

  • Height: 50 mm (+20mm with Upstand), 50 mm (Without Upstand)

  • Length: 2 m

Connectors

  • Corner piece: used where a 90 degree bend is required between channel sections

  • T-piece: used where a 90 degree junction is required to run across the floor, or to feed the discharge into the sump

  • End cap: used to blank off channel run ends or to reduce the discharge to 40mm dia before entering the sump

  • Jetting eyes: for installing onto easy push out connectors, on Corner pieces and T-pieces, using solvent weld

  • Straight connector: used to connect channel sections together